Jatin Sales And Service

Established as a Proprietor firm in the year 2021 at Ahmedabad (Gujarat, India), We “Jatin Sales And Service” are a leading Wholesale Trader and Service Provider of a wide range of Relay Card, Genset Controllers, Control Panel, etc.

Protection & Supervision:
• 3 phase Under & Over voltage protection for EB supply (True RMSmeasurement)
• Phase under & over voltage protection of Generator supply (True RMSmeasurement)
• User programmable Cranking attempt.
• Generator over speed supervision
• DC Battery Voltage supervision (Under & Over voltage)
• External fault detection (3 digital inputs)
• DG Fail to Start supervision and indication
• DG fail to Stop supervision and indication
• Unit remains fully operational even if battery voltage falls to zero volts for onesec.
• Over current protection (Only In model DGC- 6D1I)
Protection & Supervision: Measurement & Display.DGC-6D, equipped with a backlit LCD display, which displays:
• EB voltages of RYB phase
• Generator voltage
• Generator Current (Only in model DGC-6D1I)
• DC battery voltage
• Generator frequency
• RPM
• Cumulative Run Hour five digit
• Set values 
Auto/ Manual mode selection:Press A/M button for 4 sec. On pressing the button the unit selects Auto ormanual mode. Auto LED glows when the unit is in auto mode. And manual LEDlow what it is in manual mode.Auto ModeDGC-6D monitors the Mains supply, if Mains supply varies beyond set limit ofUnder and Over voltage for more than Mains supervision time, DGC-6D starts thegenset.To start the genset DGC-6D gives a cranking signal via potential free contact tocrank motor. On detection of engine start, the Crank command is withdrawn. Max duration of crank command is user settable.The maximum number of cranks is user programmable. Failure of starting ofgenerator after maximum-programmed crank attempts, result into blinking of FSTLED, indicating Fail to Start fault and the hooter is switched on.While the genset is running, DGC-6D monitors the genset for external faultLLOP, HWT, Emergency and voltage healthiness.On detection of any fault, Gen-set is stopped by the DGC-6D after set time delay& hooter is switched on.On restoration of healthy EB supply for the set time duration the Gen-set isstopped after recooling it for the user set recooling time.Load change over is automatically performed by DGC-6.Manual / Test ModeIn manual /Test mode the DG can start or stop by pressing Start and stop buttonrespectively. The main contactor can be switched on and off by pressing MCBbutton and generator contactor can be switched on / off by pressing GCB button

Established as a Proprietor firm in the year 2021 at Ahmedabad (Gujarat, India), We “Jatin Sales And Service” are a leading Wholesale Trader and Service Provider of a wide range of Relay Card, Genset Controllers, Control Panel, etc.